# So I have these two programs that I created for an assignmen

So I have these two programs that I created for an assignment, and I am trying to run them with Visual Logic, which is the program I have to use, however, I am getting an error when I run the test since there is something wrong with the output but I cannot figure it out.Simple Interest Paid – Calculation 1 Calculation to determine the amount of interest paid on a loan for the first 5 years. I = p * r * t Input variables: Principal, InterestRate, Years Process: InterestAmount= Principal * InterestRate * Years Output variables: InterestAmount Input Data module Write “What is the principal?” Input Principal Write “What is the interest rate?” Input InterestRate Write “What is the number of years for the loan?” Input Years Perform Calculations module Set InterestAmount= Principal * InterestRate * Years Output Results module Write “For a loan of “ + “\$”Principal Write “At a rate of “ + InterestRate”%” Write “Over a time period of “ + Years Write “Your total interest amount is “ + “\$”InterestAmount Bill Cost with Tip – Calculation 2 The purpose of this calculation is to determine the total bill amount with cost of tip included. Input variables: BillCost, TipPercept Processes: TotalBill = (BillCost * TipPercent ) + BillCost Output variables: TipCost, TotalBill Input Data module Write “What is the cost of the bill?” Input BillCost Write “What is the tip percentage?” Input TipPercent Perform Calculations module Set TipCost = BillCost * TipPercent Set TotalBill = BillCost + TipCost Output Results module Write “The cost of tip is: “ + “\$”TipCost Write “The total bill cost wit tip is: “ + “\$”TotalBill I need for someone to tell me how to correct this problem in order to be able to run it with Visual Logic. Again, problem is only at the output of both calculations.